This Retatrutide Cagrilintide blend holds 5mg of Retatrutide and 5mg of Cagrilintide in one sealed vial. That gives an even split and 10mg of lyophilised peptide in total.
The two compounds
Retatrutide acts at GIP, GLP-1 and glucagon. Cagrilintide is an amylin analogue, so it works through an entirely separate mechanism. That difference is precisely why researchers study the two together rather than one in place of the other. ClinicalTrials.gov holds the Retatrutide trial record.
Both compounds reach 99 percent purity or better in a single lyophilised vial. In addition, the label carries a QR code for that batch. It confirms the contents, the total amount and the batch number. Any phone camera reads it, and you need no account.
Why this blend is hard to find
Very few suppliers in Thailand stock a Retatrutide Cagrilintide blend. Cagrilintide itself stays uncommon here, and fewer suppliers still combine it in advance. Because the manufacturer blends the two at a fixed one to one ratio, the vial arrives ready for a single reconstitution.
The ratio does not move, however. So a protocol that needs the two varied independently will do better with separate vials. In that case the Retatrutide 10mg vial makes the usual starting point. You then add Cagrilintide on its own terms.
We dispatch seven days a week with a 3pm cut off. Bangkok addresses receive the vial the same day, while the rest of Thailand takes 1 to 3 days.
Storage and preparation
Keep the sealed vial at room temperature and out of direct sunlight. Once you reconstitute it, refrigerate between 2 and 8 degrees Celsius. Because both compounds share the same 10mg vial, your water volume sets the concentration of each at once. Run it through the reconstitution calculator before you order bacteriostatic water.
For laboratory research use only. Not for human consumption.
